![]() ![]() You can define up to 64 ACLs, each with up to 64 rules (or filters). See the Configure CPU ACLs section for more information. In WLC firmware version 4.0, there are CPU ACLs which can filter traffic destined for the Management Interface. Therefore, ACLs can only be applied to dynamic interfaces. ACLs on WLCsĪCLs on the WLC are meant to restrict or permit wireless clients to services on its WLAN.īefore WLC firmware version 4.0, ACLs are bypassed on the Management Interface, so you cannot affect traffic destined to the WLC you can only prevent wireless clients from the management of the controller with the Management Via Wireless option. Refer to Cisco Technical Tips Conventions for more information on document conventions. ![]() If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is based on these software and hardware versions:Ĭisco 2000 Series WLC that runs firmware 4.0Ĭisco 802.11a/b/g Wireless client adapter that runs firmware 2.6Ĭisco Aironet Desktop Utility (ADU) version 2.6 How to configure the WLC and Lightweight Access Point (LAP) for basic operationīasic knowledge of Lightweight Access Point Protocol (LWAPP) and wireless security methods Prerequisites RequirementsĬisco recommends that you have knowledge of these topics: This document describes how to configure the access control lists (ACLs) on Wireless LAN Controllers (WLAN) to filter traffic through the WLAN.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |